Pitching the tent in a few minutes

A Nordic tipi with a central pole is pitched in a few minutes. Put out pegs, spread the fabric and raise the central pole. Pitched in approximately three minutes.

You place the pegs with the mounting cross  and the measuring tape . Be careful to place the door section in the direction where you want the door to be because the pegs will be a little closer to each other at the entrance.

Olivin has got 6 pegs. Safir, Zirkon and Onyx have got 8 pegs. Safirflex and Zirkonflex have got 16 pegs.

Place the mounting cross where the central pole is to stand. Thread the measuring tape around the peg and pull it out to the mark of the tape. There you put the peg. Make sure that the tape is stretched and follows the lines of the mounting cross.

Spread the fabric out and pull the ground rings over the tent pegs with the door in the correct direction.

Assemble the central pole and put it inside the cap at the top of the Nordic tipi. Raise the Nordic tipi by pushing the central pole upwards and put the lower part of the pole in the cap of the ventilation cords. Place the central pole straight and in the centre of the tent.

Close the door and tighten the ground straps all the way round. Adjust them till you are satisfied.

Read more about

how to tighten the ground tensioners

how to avoid damages on the zip

how to avoid damages on the central pole